To restore worn details the active mineral should be present in the motor oil for some time. The huge practice of compound application shows that the best results may be achieved with multistage treatment.
The 1st stage: add Atomium Mototec 4 to the engine oil 300-400 km (4-5 moto hours) before oil replacement. Follow the next steps:
- Before applying Atomium Mototec 4 shake the can thoroughly until natural sediments are totally dissolved. Sediments are actually active components.
- Warm-up the engine to the normal working temperature, then shut off the engine,
- Pour Atomium Mototec 4 through the regular oil filling neck. Use half of the can for engines with displacement less than 500 cubic cm. and one full can for bigger engines.
- After that make a drive on the motorcycle during 10-15 min.
The 2nd stage: Change the oil. Replace oil and air filter. Add Atomium Mototec 4 to the new engine oil according to the procedure described above.
Use a motorcycle or another device in a regular mode till the next scheduled oil replacement.
All stages are shown in the table below:
Treatment stages | Engine displacement |
Less than 500 cm3 | More than 500 cm3 |
1 stage: | 1/2 can | 1 can |
| 300-400 km of mileage (4-5 motor hours) till the oil replacement. |
Change oil and oil filter |
2 stage: | 1/2 can | 1 can |
Important:
- It is not recommended to apply the lubricant at the existence of mechanical breakages of parts and assemblies
Precautions: Not harmful if applied correctly.
First aid:
- In case of contact with skin remove the material wash out with warm water, and then wash again with soap
- In case of contact with eyes wash out eyes with large amount of water
- In case of swallowing consult a doctor