Full petrol engine treatment will require three stages. At each stage one can of Atomium compound should be poured in the oil filler neck. It does not require any special knowledge or tools. This can be easily done by any car owner himself. However, it is important to pay attention to the manual which is in each compound box, so that it works as effectively as possible.
1st stage: Add Additive Atomium Active Gasoline Plus to the engine oil 500-1000 km before oil replacement. Do it as follows:
- Warm up the engine to operating temperature (normal operation).
- Turn off the engine.
- Thoroughly shake the can of Atomium compound to stir the sediments on the bottom throughout the entire volume of the liquid. It may take time and some efforts.
- Pour the compound into the oil filler neck of the engine. (If the volume of the oil system is more than 7 litres, it is necessary to pour in two cans of the compound).
- Immediately after adding the compound make a drive for 20-25 minutes in regular mode.
Note: in case if there are more than 1000 kilometers till regular oil change it is reasonable to make regular oil checks every 500-700 kilometers. In case of a significant oil contamination (identify by the color of the oil on the dipstick or oil spots on filter paper) start the second stage of treatment immediately.
2nd stage: Change oil. Replace oil and oil filter. Add Atomium Active Gasoline Plus to the new engine oil. Use car in a regular mode till the next scheduled oil replacement. No additional oil checks required,
3rd stage: Change oil. Replace oil and oil filter. Add Atomium Active Gasoline Plus to the new engine oil.
Complete treatment of the engine is performed according to the following scheme:
Oil volume in the oil pan: |
Stage | From 2 to 5 ltrs | From 5 to 9 ltrs |
1 stage: | *In engine oil is added: |
1 can | 2 cans |
| About 1000 km of mileage till the oil replacement. |
Changing the oil and oil filter |
2 stage: | 1 can | 2 cans |
| Run the car in regular mode till the oil replacement. |
3 stage | Changing the oil and oil filter |
1 can | 2 cans |
* It is necessary to carry out oil drop test every 500-1000 km if the mileage to the regular oil change is more than 1000 km. In case the oil became solid black It is necessary to make oil replacement ahead of schedule and go to the second stage.