Engine oil additive MOTOTEC 2 for engines of moto-technics

Atomium mototec 2 should be used according to the following procedure:

The 1st stage: 

• Before applying Atomium Mototec 2 shake the can thoroughly until natural sediments are totally dissolved. Sediments are actually active component.
• Warm-up the engine to the normal working temperature, then shut off the engine,
• Pour Atomium Mototec 2 into the fuel tank (the compound should be added to the fuel tank for both pre-mixed and oil-injected engines). Add 5 ml of the compound per 1 liter of the fuel in the tank.
• Start up the engine after the adding of compound and let it work for 10-15 minutes. 

Use the engine in a regular mode until the fuel tank is empty. Then use regular oil-fuel mix (or fuel for oil-injected lubrication systems) for 5 or 6 engine hours. 

The 2st stage: 

Repeat the whole procedure from the stage 1. 

After that use engine as usually for 40-50 engine hours. Then you may repeat the treatment from the beginning if you feel that engine is losing operating characteristics.

Important: It is not recommended to apply the compound at existence of mechanical breakages of parts and assemblies;

Precautions: Not harmful if applied correctly.

First aid:

•  In case of a contact with skin remove the material wash out with warm water, and then wash again with soap
•  In case of contact with eyes wash out eyes with large amount of water
•  In case of swallowing consult a doctor