Additive for trucks MAX ENGINE

Tribotechnical compound MAX ENGINE is applied in four stages in accordance with the following procedure:

1. Warm up the engine to operating temperature (regular operation).
2. Stop the engine.
3. Stir the compound thoroughly until natural sediments (active components) are totally dissolved.
4. Pour the composition into the oil filler neck of the engine at the rate of 5 ml per 1 liter of oil (see the marks on the end of label).
5. After applying the engine should run (it is recommended to drive the car) for no less than 20 - 25 min in the regular operation mode.
6. After the procedure, you can use the car as usual.
7. After the procedure you can use the car as usual.

Full treatment is performed as follows:

For engines with mileage more than 200 000 km:

For engines with mileage more than 500 000 km:

The required amount of compound for each stage of engine treatment is determined from the rate of 5 ml to 1 liter motor oil. The number of stages depends on the car's mileage:

• up to 200 000 kilometers – 2 stages;
• up to 500 000 kilometers – 3 stages;
• more than 500 000 kilometers – 4 stages;