Atomium Reducer 80
Effects of application
Compound REDUCER partially restores the dimensions and geometry of worn parts, optimizes gaps in friction pairs, keeps a denser oil layer on the friction surfaces. This allows to:
reduce noise and vibration levels. Optimization of gaps and restoration of the optimum spacing in bearings reduce noise and vibration during operation of the unit;
increase the car free run (in neutral gear). Retention denser oil layer on the surface reduces the frictional losses and increase free run: movement of the car in neutral gear;
increase the lifetime. Protective layer on the friction surfaces and dense oil layer substantially reduce wear and increase the lifetime of the unit.
Tribotechnical compound «Atomium Reducer»
Compound Reducer is designed for protection against wear, increasing the lifetime and restoration of characteristics of transfer cases, differentials and other reducers in passenger vehicles and light trucks.
Tribotechnical compound Reducer
Certified in accordance with the international quality standard
Standard TU 0254-003-79761558-2009
Storage temperature: from -20 ᵒС to +70 ᵒС
Shelf life: 5 years
Safety precautions and first aid:
It is not expected any health hazard when used under normal conditions.
In case of a contact with skin, wash out with warm water, and then wash again with soap.
In case of contact with eyes, wash out eyes with large amount of water.
In case of swallowing, consult a doctor.
Shelf life: 5 years. Manufacturing date is indicated on the can.
It is not recommended to apply the compound at existence of mechanical breakages of parts and assemblies.
Compound REDUCER is compatible with any type of transmission oils, including automatic transmission fluid (ATF).
The sediment on the bottom of the can is the main working element of REDUCER - these are microparticles of minerals. It is crucially important to stir contents of the can thoroughly before pouring it in the gearbox oil system (sediment color depending on the release batch can vary from light green to black).
Compound REDUCER does not interact with friction clutch and does not violate the clutch operation.
Overdose of compound by 1.5-2 times is not dangerous for the reducer and does not disturb its work.
Compound REDUCER does not affect the characteristics and status of parts made of composite materials and rubber.
Instructions for application
Treatment of transfer cases, differentials and other reducers is made in accordance with the following procedure:
Warm up the unit up to operating temperature (regular operation) and operate it under the working load for15-20 minutes.
Stop the engine
Stir the compound in the can thoroughly until natural sediments (active components) are totally dissolved.
Apply 1 can of the compound through regular filling neck. It is enough for treatment of the units with transmission fluid volume from 0.7 to 2.2 liters.
Immediately after applying it is recommended to drive the car for no less than 20 - 30 min. in regular operation mode.
After the procedure you can use the car as usual.
To provide continuous level of protection of the unit it is recommended to apply the compound further after each scheduled replacement of transmission fluid.